Water Heater Maintenance Houston

water-heater-maintenance-houston

Water Heater Maintenance Must Do For Prolong Life Of The Heater

Very few people know that in order to keep your water heater running properly and efficiently very simple maintenance procedures need to be performed.If left unchecked they can not only make your water heater work harder but also allow your tank to rust and slowly be eaten away until you need to replace the entire unit which is very costly yet easily preventable.

earn about your water heater and what you can do to prolong the life of the heater.

 

How to Maintain A Water Heater

Test the TPR Valve

Shut off the power and the cold-water supply valve. Place a bucket under the pipe connected to the temperature-pressure-release (TPR) valve on the top or side of the tank. (This valve opens if the tank pressure gets too high.) Lift the valve’s tab to let some water out, then let go. If water keeps flowing, drain the tank partway, unscrew the old valve with a pipe wrench, and install a new one.

Check the Anode Rod

Put a hose to the tank’s drain cock and let out a few gallons of water. Now fit a 1 1/16-inch socket onto the rod’s hex head on top of the heater (or under its top plate) and unscrew the rod. If it’s less than ½ inch thick or coated with calcium, buy a new one, wrap its threads with Teflon tape, put it back in the tank, and tighten securely. Use this segmented rod if headroom above the tank is limited.

Drain the Tank and Wash Out Sediment

Drain the remaining water in the tank into the bucket, then stir up the sediment on the tank’s bottom by briefly opening the cold-water supply valve. Drain and repeat until clean water comes out of the hose. Close the drain cock, refill the tank, and turn its power back on.

Adjust the Temperature

 Find the temperature dial on the side of the tank and unscrew its cover. Adjust the dial to 120 degrees using a flathead screwdriver. For every 10 degrees the temperature is lowered, you can expect to save up to 5 percent in energy costs. Turn the water heater off or the thermostat down to its lowest setting if you plan to be away from home for more than three days.
 

Insulate the Pipes

Buy some self-sticking 3/8-inch-thick foam pipe insulation that matches the pipes’ diameter. Slide the foam over the hot- and cold-water pipes as far as you can reach. Insulating the cold-water pipe prevents condensation in summer. Peel the tape and squeeze the insulation closed. If the pipe is 6 inches or less from the flue, cover it with 1-inch-thick unfaced fiberglass pipe wrap.

Insulate the Heater

Cut the insulating blanket (shown: R-4.5 foil-covered bubble wrap) to fit around pipes, the TPR valve, and the temperature control sticking out of the tank. Wrap the side of the tank, and seal cuts with foil tape. Do not cover the tops of oil or gas heaters. Cap an electric heater with an oversize circle of insulation, and tape its edge securely to the side of the tank.

Water HeaterMaintenance Is Important

Over time, your water heater’s tank accumulates debris. This debris includes small pebbles, sand, dirt and rust. As this debris builds up it can have a negative effect on the performance of your home’s water heater and the quality of hot water throughout your home.Water heater maintenance is also known as a ‘drain and flush’ service, and the name pretty much says it all. A professional plumber will drain your water heater’s tank and flush away all of the debris and build-up that has formed in the tank. Call (713) 812-7070 us for your home service and repair needs.

For more related articles and info visit https://www.abacusplumbing.net/category/plumbing/

live chat software